Steel arc welded sheet forming a rigid load-bearing structure. The special configurations allows for high accessibility to components. The disposal of the components, the battery on the rear axle and the front traction-steering unit make very stable machine.
The rear axle is provided, in the model SE-SM, with a suspension for a better comfort of the driver.

It is composed of an oil-filled reduction gear and it is moved by a powerful motor, A.C. type in the model SE-SM. It is connected to the frame by a ball-bearing fifth wheel of big dimensions.
The traction unit have the motor assembled vertically for a better ventilation and protection against Impacts and dirt.

The machine is normally braked by the electronic system which acts the motor and slackens its speed when the accelerator is released. A higher reverse current braking is always possible by means of the chopper. A negative solenoid brake acts as safety and parking brake. In the model SE and SM an hydraulic system, moved by a pedal , acts on the rear wheels.

It is created to ensure the comfort for a half-sitting operator; its base is very low, allowing to go up/down continually and comfortable. In the model with manual steering, the driver use a tiller while in the model with electric steering, the operator use a small steer. In both the machines the direction and the speed are obtained by drive throttles.
The desk board Nave a battery
discharge indicator that show hours of work and eventually faults. There are then the start key, the tight switch and the horn button.

Mainly composed of an electronic control , D.C. for the 2Tons machines and A.C for the bigger models, which guarantees the machine power at low speed, a good maximum speed, the movement control, the regenerative braking and the counter current brake.

They are, in reference to the type of the machine, of big dimensions. Covered by polyurethane or rubber.

The machines complies with the effective standards with respect to components, performances and stability.